Z-LOADER on MT7621

gistfile1.txt

U-Boot 1.1.3 (Aug  6 2018 - 14:37:41)

Board: Ralink APSoC DRAM:  128 MB
relocate_code Pointer at: 87f98000

Config XHCI 40M PLL 
******************************
Software System Reset Occurred
******************************
Allocate 16 byte aligned buffer: 87fcb030
Enable NFI Clock
# MTK NAND # : Use HW ECC
NAND ID [C2 F1 80 95 02]
Device found in MTK table, ID: c2f1, EXT_ID: 809502
Support this Device in MTK table! c2f1 
select_chip
[NAND]select ecc bit:4, sparesize :64 spare_per_sector=16
Signature matched and data read!
load_fact_bbt success 1023
load fact bbt success
[mtk_nand] probe successfully!
mtd->writesize=2048 mtd->oobsize=64,    mtd->erasesize=131072  devinfo.iowidth=8
....============================================ 
Ralink UBoot Version: 5.0.0.0
-------------------------------------------- 
ASIC MT7621A DualCore (MAC to MT7530 Mode)
DRAM_CONF_FROM: Auto-Detection 
DRAM_TYPE: DDR3 
DRAM bus: 16 bit
Xtal Mode=3 OCP Ratio=1/3
Flash component: NAND Flash
Date:Aug  6 2018  Time:14:37:41
============================================ 
icache: sets:256, ways:4, linesz:32 ,total:32768
dcache: sets:256, ways:4, linesz:32 ,total:32768 

 ##### The CPU freq = 880 MHZ #### 
 estimate memory size =128 Mbytes
#Reset_MT7530
set LAN/WAN WLLLL
.## Starting application at 0x81E00000 ...


Z-LOADER V1.28 | 08/06/2018 14:37:44


..
Checking image 1...
   Image Name:   3.10(XIP.1)b3
   Image Type:   MIPS Linux Kernel Image (lzma compressed)
   Data Size:    1583402 Bytes =  1.5 MB
   Load Address: 80001000
   Entry Point:  80001000
.........................   Verifying Combo Checksum ... ...................................................................................................