ApexFPV Stack resources

0_ApexF7Stack.md

Apex F7 Flight Controller:

• Built-In Blue-Tooth module for easy configuration from your mobile
• USB Type-C connector
• DJI Compatible connector
• Optional secondary MPU connection
• Barometer
• Main MPU-6000
• 5 UARTS
• Betaflight Target APEXF7
• Input Voltage: 9-36v (4s-6s)
• Main CPU: STM32F722
• Main MPU: Invensense MPU-6000
• Barometer: mna
• OSD: AB7456
• Onboard Flash: 16mb
• Betaflight Target: Here
• Serial ports (UART): 6
• 5v regulator : 2A
• 10v regulator : 2A
• manufactured by AirBot

Informational resources:

• https://www.facebook.com/ApexFPV/
• https://youtu.be/d3_OzwlcPKw
• https://zdrone.co.il/product-category/apex/
• https://pyrodrone.com/products/apex-f7-stack-w-60a-esc
• https://apexfpv.eu/product/apex-f7-flight-controller/
• https://github.com/betaflight/unified-targets/blob/master/configs/default/APEX-APEXF7.config
• https://github.com/betaflight/betaflight/blob/master/src/config/APEXF7/config.h
• https://github.com/emuflight/EmuFlight/tree/master/src/main/target/APEXF7

Image my_wiring_v2.png and ELRS-wiring.png is my personal working/flying wire diagram.

• Credit to Gal Kremer for some of the included images.

APEX_120426842_341201720652403_1353976458538676827_n.jpg

ApexESC.jpg

ApexESC_board.jpg

ApexF7_GalKremer_FC-Bottom.png

ApexF7__100073632_245089133596996_4468337610862886912_n.png

ApexF7__99087816_242956133810296_4864799784189296640_n.png

ApexF7_GalKremer_FC-Top.png

ELRS-wiring.png

fixed00.png

fixed01.png

my_wiring_v2.png

official-apexf7-Wiring.png

for Express (ELRS):

feature RX_SERIAL
serialrx_provider = CRSF
set serial_inverted = OFF
serialrx_halfduplex = OFF

serial 0 64 115200 57600 0 115200  ##if soldered as instructed below (UART1, set to only "serial RX" toggle)

save

Solder ELRS-Receiver's TX-Pad to FC's SBUS-Pad & solder ELRS-Receiver's RX-pad to FC's TX1-Pad.
set UART1 in modes tab for Serial RX.

Modes-Tab to your liking, but arming must be AUX1. can modify physical switch to AUX & Channels in OpenTX/EdgeTX

Cam Control (CC) did not need any ports-tab peripheral-assignment for my Foxeer Cat 3.