Intel e1000e fix - Proxmox

fix.md

Fix Intel e1000e error

Please note - you may want to validate whether the options used affect your setup.

Create a new service file.

nano /etc/systemd/system/disable-offloading.service

Paste the required information/command in the newly created service file - please change eth0 to your desired adapter.

[Unit]
Description=Disable NIC offloading
After=network.target

[Service]
Type=oneshot
ExecStart=/sbin/ethtool -K eth0 gso off gro off tso off tx off rx off rxvlan off txvlan off sg off
RemainAfterExit=true

[Install]
WantedBy=multi-user.target

Load the new service file and enable on reboot.

systemctl daemon-reexec && systemctl daemon-reload && systemctl enable disable-offloading.service

Another suspect:

5. Disable EEE.

What makes me add EEE to the list of suspects is this from an driverupdate by Intel in 2019 (might have existed sooner):

https://web.archive.org/web/20210802085934/https://downloadmirror.intel.com/15817/eng/readme.txt

82573(V/L/E) TX Unit Hang Messages
----------------------------------
Several adapters with the 82573 chipset display "TX unit hang" messages during
normal operation with the e1000edriver. The issue appears both with TSO enabled
and disabled and is caused by a power management function that is enabled in
the EEPROM. Early releases of the chipsets to vendors had the EEPROM bit that
enabled the feature. After the issue was discovered newer adapters were
released with the feature disabled in the EEPROM.

If you encounter the problem in an adapter, and the chipset is an 82573-based
one, you can verify that your adapter needs the fix by using ethtool:

 # ethtool -e eth0

Offset	Values
------	------
0x0000	00 12 34 56 fe dc 30 0d 46 f7 f4 00 ff ff ff ff
0x0010	ff ff ff ff 6b 02 8c 10 d9 15 8c 10 86 80 de 83
                                                        ^^

The value at offset 0x001e (de) has bit 0 unset. This enables the problematic
power saving feature. In this case, the EEPROM needs to read "df" at offset
0x001e.

A one-time EEPROM fix is available as a shell script. This script will verify
that the adapter is applicable to the fix and if the fix is needed or not. If
the fix is required, it applies the change to the EEPROM and updates the
checksum. The user must reboot the system after applying the fix if changes
were made to the EEPROM.

Example output of the script:

# bash fixeep-82573-dspd.sh eth0
eth0: is a "82573E Gigabit Ethernet Controller"
This fixup is applicable to your hardware executing command:
# ethtool -E eth0 magic 0x109a8086 offset 0x1e value 0xdf
Change made. You *MUST* reboot your machine before changes take effect!
The script can be downloaded at
http://e1000.sourceforge.net/files/fixeep-82573-dspd.sh.