Successful mitmproxy setup tested on OS X 10.11.1 and iPad running 9.0.2
Enable IP forwarding and disable ICMP redirects to keep traffic flowing through the MAC
sudo sysctl -w net.inet.ip.forwarding=1
sudo sysctl -w net.inet.ip.redirect=0
net.inet.ip.forwarding
Enable IP forwarding between interfaces \IP forwarding is the process of forwarding internet packets from one network to another. By default the FreeBSD system will not forward IP packets between various network interfaces. In other words, routing functions (also known as gateway functions) are disabled.
type: boolean, default: off
net.inet.ip.redirect Enable sending IP redirects Allow (1) or disallow (0) send ICMP redirections when forwarding. This option is ignored unless the host is routing IP packets. Normally, this option should be enabled on all systems.
type: boolean, dafault: 1
Create a new file with the following pf rules. Replace ext_if and ext_ip with the appropriate values.
ext_if = "en0"
ext_ip = “192.168.1.141”
rdr on $ext_if inet proto tcp from any to any port 80 -> $ext_ip port 8181
rdr on $ext_if inet proto tcp from any to any port 443 -> $ext_ip port 8181
Load your file with pfctl and then enable pf
sudo pfctl -vf pf.conf
sudo pfctl -e
Add pfctl to /etc/sudoers
ALL ALL=NOPASSWD: /sbin/pfctl -s state
Start mitmproxy
mitmproxy -T -p 8181 --host
Statically configure the IP address of the machine running mitmproxy as a router on the iPad, make sure both devices are on the same network and any AP isolation mode is disabled.
Install the CA cert on the iPad by visitng https://mitm.it
[1] http://www.cisco.com/c/en/us/support/docs/ip/routing-information-protocol-rip/13714-43.html [2] http://docs.mitmproxy.org/en/stable/transparent/osx.html [3] https://notroot.wordpress.com/2010/10/22/freebsd-net-inet-ip-sysctls-explained/
Question. How do you "Statically configure the IP address of the machine running mitmproxy as a router on the iPad"?
@joshenders